Custom made by Assembled Products, Inc., this nifty little fuse holder is great for almost and Electric Vehicle project. Simplifies the task of mounting up the primary fuse in a safe and electrically efficient manner! Works with any ANN style or similar mounting style fuse.

 

Fuse holder securely holds the input and output cables securely, even while changing the fuse! By holding both cables securely, the fuse can be changed easily without worry of an accidental electrical short.The fuse is changed by loosening the outer nuts and easily replacing the old fuse with the new one between the included copper washers.

 

The backing plate of the fuse block is 1/2" thick fiberglass substrate which resists bending and cracking. In addition, the substrate is fire and heat resistant. the fuse block is approximately 2 inches by 4.5 inches. The fuse bolts are 5/16" studs mounted on 2.5 inch centers and recessed in the substrate to prevent spinning.

 

Two different mounting styles available: with or without mounting 5/16" mounting bolts. Assemblies with mounting bolts are recessed and potted to prevent accidental shorting.

 

Fuses and wire terminals sold seperately and not included with fuse holder. All hardware is copper and brass.